Solved

Engine Wear

I have been testing this for the past 4 races and I see a few wee details missing or not right in the viewer and race data.

I currently have one car going into Monaco with roughly a 54% engine (same engine used since Australia) and the other with 100% (new engine) to get screen-shots, but even without them, what I have found is there is no difference in Top speed or Acceleration in the race viewer. The car is just slower without showing any visual reasons as to why it is slower. Even the after race data the average speeds are the same as everyone else.

I have found the speed indicated in the viewer never seem right.... If you do a full kers lap and the time sheets after show a top speed of 350km... but when your watching it live it never hit that speed apparently.

It's too hard to tell the top speed in the data I think is just top average speed, here is Spain Yesterday 64% engine and Last season 100% engine

Practice shows a lot, but sadly you cant see this unless you have an old and new engine in use. Slower times and uses more fuel.

Also interesting is the fact your tire wear changed between runs 1&3 for both

runs 1 & 2 where on natural Greg, then up to very high for the rest.

here we have same top speed.

Single engine used for 7 races looks like this:


Enough life to 2 more races but far too slow to do anything. Now I need to use up some engines as restock is in 2 races, but more important need score points to avoid relegation. Yikes!!